In doing my roof maintenance here in Colorado this week, I noticed that the snap in beauty strips that cover the screws which fasten the channel that secures the TPO edges had started to pop off on the front. Looking a bit further, it was caused by several of these screws backing out and pushing the strip off. I tightened up about 7 or 8 screws and noticed that a few screws had never been installed. I could see the pre-fabbed holes in the aluminum channel, but, the holes had never been drilled and screwed. I want to install these last screws and hopefully not experience this again.The trailer's covered now, so:
What's the screw size? Also, we're these left out for any reason like a wiring circuit to the awning or something?
What's the screw size? Also, we're these left out for any reason like a wiring circuit to the awning or something?
Comment