Disclaimer: In general, this forum is intended to be a place for Grand Design owners to gather and exchange ideas regarding their use of and experiences with Grand Design products. Any information contained in the forum should be independently verified by checking with Grand Design, one of its authorized dealers, or reviewing your owner’s manual.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will need to to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below. Thanks for visiting and your interest in Grand Design!
Chris, I have an 2021 model 303. You could cut the inside front wall near the battery disconnect switch, wire in the plug as shown above, then using an extension cable run the power chord out through the wiring bulkhead in the plastic tray on the trailing side of the basement. You could even instal a bulkhead on the leading side of the plastic tray. That way no holes in the side wall.
Tweet
Comment