Here's the 7-pin scheme.
Announcement
Collapse
No announcement yet.
Clicking in front storage bay
Collapse
X
-
Problem? What problem?? Good news and thank
you all who replied and helped. All comments were
very much appreciated and valued. I got it working,
it’s not clicking anymore and everything works.
I just wish I had a definitive answer as to why it
wasn’t working and why it is now? Here’s what I did…
Finally traced the wire related to the clicking
auto-reset circuit breaker to the electrical junction
box up inside (facing bottom) of the turning point
king-pin with 7-pin wires coming out of it and a bunch
of wires going into that box. (Thanks for
pointing me in that direction Country Camper & howson)
The hot wire Going into junction box which has
the 2-wire locking tab mechanism. That ohmed out
(had continuity) just fine on both ends. The 4-white
wires and the related mostly white wire with thin red
strip on it were all (5 total ) common wires stuffed into
very large blue wire nut. I Found my related wire and
found the other end going through a hole behind
battery In the wall structure by removing bottom cover
under storage area. There was another same kind of
very large wire nut with the 5-wires stuffed in it. I
Separated them all and found my wire and it ohmed
out good; so that perplexed me. I also swapped two
30-amp reset circuit breakers with the related
one that was clicking. I reconnected all of the wires
on both ends using same large blue wire nuts.
Put it all back together and it all works? No clicking.
No issues. All devices are working. Possibly
the related wire wasn’t making contact in on of those
large wire nuts? Idk? It seemed to be good contact
when I removed the large wire nuts and tape? Idk,
again wish I had a better definitive black & white
resolution to tell you, but I don’t. However, maybe
this forum conversation might help somebody else
troubleshoot a similar issue down the road.
Thanks again !!!
2021 Reflection 150 260RD
Comment
-
Jojo2018
You may want to remove those large wire nuts and replace with a buss bar or similar, wire nuts do not hold well while a vehicle is in motion, I fear you may have this issue arise at some other time. Thanks for sharing.
BrianBrian & Michelle
2018 Reflection 29RS
2022 Chevy 3500HD
Comment
-
Thanks for the 7-pin out schematic.
And good suggestion on getting rid of the large
wire nut, I was planning on it too. Bad Design
by Grand Design. Go figure, not so Grand. It’s
probably a cost cutting measure to use them.2021 Reflection 150 260RD
Comment
-
A lot of people replace the metal junction box with one of these https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 this gives a better place for making all of those connections. When I did mine, everything ended up with a ring terminal on a post.Joseph
Tow Vehicle: 2024 GMC K3500 Denali Ultimate Diesel
Coach: 303RLS Delivered March 5, 2021
South of Houston Texas
Comment
Comment