Lippert Components error code

[Love2GoFastUSCG]

Imagine 3110BH. I went to bring the slide and and no go. On the Dual motor synch controller I get a motor 1 wire short between controller and motor. How do I fix this?

[Love2GoFastUSCG]

Ok did the electronic manual override and slide moved in but one side is about a inch not in.

[Country Campers]

Ok did the electronic manual override and slide moved in but one side is about a inch not in.

Run the slide out the full way and then back in the full way , hold the switch for 5 or so seconds each way. This should get the motors back in sync.

Brian

[Love2GoFastUSCG]

Got it to work. I pulled all the way in and back out then in. Appreciate the quick response.

Brent

[Country Campers]

Make sure that you have a well charged battery. The schwintec slides seem to be finicky when it comes to battery voltage , even when connected to shore power.

Brian

[Love2GoFastUSCG]

Make sure that you have a well charged battery. The schwintec slides seem to be finicky when it comes to battery voltage , even when connected to shore power.

Brian

Good point. We arrived at the campground and it seems like one side was lagging when I went to put it out. I helped it out by pushing a little like the manual said to as we had to cook dinner. I will have to check the voltage drop when we go to put it back in on Sunday.