Disclaimer: In general, this forum is intended to be a place for Grand Design owners to gather and exchange ideas regarding their use of and experiences with Grand Design products. Any information contained in the forum should be independently verified by checking with Grand Design, one of its authorized dealers, or reviewing your owner’s manual.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will need to to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below. Thanks for visiting and your interest in Grand Design!
Cate&Rob how do you clean your slide out gears? Lippert has always said soap and warm water. Do you lubricate the gears?
I lubricate the drive mechanism inner tube (where this "floating" seal is) and the alignment gear axles with Teflon spray. I don't lubricate the gear teeth to the alignment racks. Early on, I had a lot of squealing as the slides were retracting. Grand Design techs lubricated the system as described until the squeal went away and I maintain this every few months.
Comment