Announcement

Collapse

Need help?

Please include the year, make and model of your GDRV ("2019 Reflection 315RLTS") along with the make and model of the component with the issue ("Dometic RM1350 refrigerator", "Furrion FMCM15-BL microwave", etc) in your question.
See more
See less

Propane quits flowing.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Propane quits flowing.

    We have a 2018 Imagine 2500. Our stove will only light if I close and disconnect tank. After a while I will connect tank. Open slowly. Go in and the burners will light. Let them burn a while. Shut them off and they won't re-light unless i go through the close, disconnect, connect and open process again.

  • #2
    Originally posted by swally View Post
    We have a 2018 Imagine 2500. Our stove will only light if I close and disconnect tank. After a while I will connect tank. Open slowly. Go in and the burners will light. Let them burn a while. Shut them off and they won't re-light unless i go through the close, disconnect, connect and open process again.
    First welcome to the forum. When you get a chance please read the welcome letter.

    First check the propane lines to make sure all valves are open and no kinks. There should be a valve below the kitchen running along the frame. This may sound dumb but is your tank full? Do you have the selector switch on the regulator turned to the tank you are using. I remember a post where the lever was turned to the middle between the tanks and it caused issues.Try having both tanks open and see what happens and try switching to the other tank.

    Hope this helps
    Keith

    BTW pictures of your tanks and regulator lever setting might help.
    2018 Reflection 150 Series 220RK 5th wheel. Reese R20 Titan hitch, Steadyfast system, 2004 F350 King Ranch dually

    Comment


    • #3
      Originally posted by swally View Post
      We have a 2018 Imagine 2500. Our stove will only light if I close and disconnect tank. After a while I will connect tank. Open slowly. Go in and the burners will light. Let them burn a while. Shut them off and they won't re-light unless i go through the close, disconnect, connect and open process again.
      The two-stage regulator is a common failure item. In your shoes that's the component I'd suspect and replace.

      Let me quickly add that I am far from a propane expert--just passing along what I've (often) read.

      Noted that was your first post, so please take a moment to learn more about Grand Design's forum by reading the Welcome Letter to New Members at https://gdrvowners.com/forum/main-fo...to-new-members

      Please post back with the resolution--information sharing is the power behind an owners' forum!

      Howard
      Forum moderators are not GD employees--we are volunteers and owners presumably just like yourself. Unless specifically mentioned otherwise, we have nothing to gain should you choose to purchase a product or engage a service we discuss on this forum.

      Howard, 2017 Ford F-350 DRW, '19 315RLTSPlus

      Comment


      • #4
        Rirst, let's see if you have a propane delivery problem or a stove problem.

        If you turn the water heater to "gas", does it light? Does the furnace light and run a full cycle? If so, then it's most likely a problem with your stove or the lines running to the stove.

        Jim
        The moderators for this site are not GDRV employees, but we do own GDRV products.

        Jim and Ginnie
        2017 Reflection 297RSTS

        Comment


        • #5
          Furnace and water heater not lighting. I did just notice a humming sound from the regulator when turned on the gas valve

          Comment


          • #6
            Originally posted by swally View Post
            Furnace and water heater not lighting. I did just notice a humming sound from the regulator when turned on the gas valve
            I’d suspect the regulator or kinked line then. Does it do the same thing regardless of which tank you point it to?
            Neil Citro
            2018 Reflection 28bh
            2019 F350 6.7L Long Bed Crew Cab

            Comment


            • #7
              Could be a bad propane tank valve. They have a safety valve built into them and if there is a problem with it or the connector it can cause issues.

              Do you have dual tanks? Have you tried running off the other tank? May sound like a dumb question, but this will eliminate the tank as being the problem if it does it with both and point you toward the selector valve / regulator assembly.
              Joseph
              Tow
              Vehicle: 2018 GMC K2500 Denali Diesel
              Coach: 303RLS Delivered March 5, 2021
              South of Houston Texas

              Comment


              • #8
                I have tried both tanks. Going to go with a new regulator. Let you know how it turns out. Thanks for all the help.

                Comment


                • #9
                  Ours did the same thing, it was the regulator. They replaced it with a different model. The fancy ones with the gauges from the factory are crap.
                  2017 GMC Denali 3500 Duramax w/ Curt A20 hitch
                  2021 GD Solitude 380FL

                  300 watt solar package, 2000 watt inverter option,
                  2 6 volt 245 A/hr batteries, Surge Guard 35550

                  Comment


                  • #10
                    I got a new regulator. All good for now. Thanks for the info.

                    Comment


                    • #11
                      Originally posted by swally View Post
                      I got a new regulator. All good for now. Thanks for the info.
                      Thats great, thanks for the update!
                      Neil Citro
                      2018 Reflection 28bh
                      2019 F350 6.7L Long Bed Crew Cab

                      Comment


                      • #12
                        Hi, 2020 2670MK - all kinds of Propane issues. Stove would not get gas, furnace would not work, refrigerator would not work (although I bought a new Circuit Card - and it works now) Replaced the OE hoses to the tank with new Stainless jacketed ones with Gauges and then finally replaced the Regulator - Everything works. Although I still think there is an issue with the Batter On/OFF Switch and whether things work.

                        Comment

                        Working...
                        X