I came up short....not my height either, but it fits.
Thought I would post this question separate from my MultiPlus install. I am getting down to the Touch 50 screen wiring, etc.. I can see the light at the end of the tunnel - just hope its not the express headed toward me.
I need to extend the cabling on my Touch 50 screen to reach the Cerbo GX. It appears to be a standard HDMI and USB cable with male ends attached on the touch 50 screen. As they are male ends it appears I need two Female by Female adapters (one HDMI and one USB) and the two standard cables to extend to the Cerbo GX (one HDMI and one USB ) standard Male by Male cables. The Cerbo CX has female ports. Do they need to be any specific version 3.0 or 3.1 on USB and 2,0 or better on HDMI cable? Please advise me what to get. I have Walmart and Office Depot available.
Also to tie the Multiplus to the Cerbo GX it appears I use the same RJ45 UTP cable I used for programing and plug it into both. I am just verifying what the diagrams on the Victron site are saying and from what I understand the Cerbo GX and Multiplus manuals are saying.
Thanks
Keith
Thought I would post this question separate from my MultiPlus install. I am getting down to the Touch 50 screen wiring, etc.. I can see the light at the end of the tunnel - just hope its not the express headed toward me.
I need to extend the cabling on my Touch 50 screen to reach the Cerbo GX. It appears to be a standard HDMI and USB cable with male ends attached on the touch 50 screen. As they are male ends it appears I need two Female by Female adapters (one HDMI and one USB) and the two standard cables to extend to the Cerbo GX (one HDMI and one USB ) standard Male by Male cables. The Cerbo CX has female ports. Do they need to be any specific version 3.0 or 3.1 on USB and 2,0 or better on HDMI cable? Please advise me what to get. I have Walmart and Office Depot available.
Also to tie the Multiplus to the Cerbo GX it appears I use the same RJ45 UTP cable I used for programing and plug it into both. I am just verifying what the diagrams on the Victron site are saying and from what I understand the Cerbo GX and Multiplus manuals are saying.
Thanks
Keith
Comment