Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Just to add to Country Campers excellent recommendation; with 12-volt power back on check down current side of the resetting breakers to ground for 12.5-volts....
- 1 like
-
Not trying to pick a fight but do want to note that I leave our gray drain valve open, except when traveling or draining the black tank. We started out...
Leave a comment:
-
With the hole at ankle level, I feel pretty confident in saying that the leaking is due to an in-rush of water into the gray tank that temporarily pushes...
- 1 like
Leave a comment:
-
In answer to timh0042 second question, I would not remove the damaged awning until I'm ready to make the swap. I might wrap and tape the existing to...
Leave a comment:
-
Where is the hole in the tank vent pipe in relationship to the kitchen sink drain? And how much water is leaking at any one time; just dripping or a...
Leave a comment:
-
Haas2Travel . the vents will have a black cap on them where they project through the roof.
For the gray tank, if you're in a park with a...
Leave a comment:
-
IceMan probably has already figured out that the next step is to determine if it is the Command Center, the awning motor, or the wire connecting the...
Leave a comment:
-
If the awning was attempting to unroll but the arms not moving, I would suspect that the arms were slightly twisted, or the arm bases had moved just enough...
Leave a comment:
-
Some questions for you:
When you attempt to extend the awning, is there any movement at all of awning? Is there any noise (humming or clicking)...
Leave a comment:
-
X2 on Neil's comment. Also, the microwave may be on it's own dedicated circuit. Recheck the breakers and make sure the microwave breaker hasn't tripped....
Leave a comment:
-
No personal experience, just spit balling.
You may be able to attach the track for the topper (the awning that goes over the slide) below...
Leave a comment:
-
Welcome to the forum. One of the moderators will be along shortly with guidance on reading the welcome letter and setting up your signature line....
Leave a comment:
-
d2reid , I give up. Exactly what are the two plates suppose to do. It looks like they are screwed to the interior wall on the outside of the inner bulb...
Leave a comment:
-
As the issue is in a slide, the problem may be the splice/transition from solid copper wire to flexible stranded wire. My understanding is that this...
Leave a comment:
-
If I was a betting man, which I'm not, I would bet that the overflow on the auxiliary tank was installed lower than it should be.
Flow is...
- 1 like
Leave a comment:
-
No, LisanJim , it is not good for the trailer to jerk back and forth when not braking or accelerating. There will be some play in the hitch, it isn't...
Leave a comment:
-
Welcome to the forum. Others will be along with reminders to read the welcome letter and set up your signature line.
First, we are not going...
- 2 likes
Leave a comment:
-
Before using compressed air to blow out the faucet line, I assume you are planning on removing the spray head/nozzle from the discharge end of the line....
Leave a comment:
No activity results to display
Show More
Leave a comment: