Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Most of the connections GD makes are up under the coroplast. Try pulling a corner down in the area of damage, Looks to me like they pulled out of a knife...
-
Jim is correct, it's bad and don't count on it holding. Been there and tried that only to have a bigger mess. Home depot will have an exact replacement...
Leave a comment:
-
To the best of my knowledge GD has never wired in backup lights. In your case pull the light and double check for wires. My guess they did not connect...
Leave a comment:
-
If you don't mind drilling a hole, you can use wall mollies designed for the thin plywood
Hope this helps
Keith...
- 1 like
Leave a comment:
-
. Have you called GD customer service. They may know of sources. They helped me find a replacement stove vent. Have your vin number handy....
Leave a comment:
-
Please take pictures as I am planning something simular
Thanks Keith...
Leave a comment:
-
First welcome to the forum. When you get a chance please read the welcome letter.
First check the propane lines to make sure all valves are...
Leave a comment:
-
Appreciate your thoughts. The Xantrex and Go Power are both UL approved and more. My planed battery bank is 4 - 6V Crown CR-260 deep cycle batteries...
Leave a comment:
-
Xantrex brand inverters and inverter charger with comparison to others
OK folks I cam out of my corner to get myself in trouble.
Background - I have been researching inverter choices in the 3000W range. The unit I am...
-
I have the Viair 450P-RVS got it from these folks https://www.technorv.com/viair-450p-...-a-motorhomes/ Best price when I was looking....
Leave a comment:
-
There is the off chance that a good glass company can do a replacement. My old trailer had similar windows and I found a place that could do it. Might...
Leave a comment:
-
A few pictures might help. Is the control center on the wall with the toilet behind? Or is it on the wall withe sink and cabinet behind? Do you know how...
Leave a comment:
-
Thanks Curtis The Go power inverter I am looking at ISW300 does not have a pass through https://gpelectric.com/products/3000...wave-inverter/
-...
Leave a comment:
-
Neil
How loud was the fan at full power on you Magnum 2812 ? I have been told my GP 3000 I was looking at sounded like a jet engine winding up....
Leave a comment:
-
Sweet - Thanks. Ill add this to my must get list.
Have a great week
Keith...
- 1 like
Leave a comment:
-
Love to see pictures when your done. I did notice you could stack them too.
Enjoy
Keith...
- 1 like
Leave a comment:
-
Any good plumbing supply store will have it as will some hardware stores. You can give a plumber a call and find out where they get it too. Also look...
Leave a comment:
-
I just measured my 8awg wires.Two 8 awg PV wires place side by side is 5/8" so hopefully you have at least a 3/4" tube. Where did GD place your...
Leave a comment:
-
Howard - great clip.
I have have visited the Dinosaur web page and can find no matching number for my board.. I have emailed them 3 times...
Leave a comment:
-
Dang it you guys there you go again on what to spend my money on - yep saw the new ones this morning. Brian (I am so jealous) bertschb did you happen...
Leave a comment:
No activity results to display
Show More
Leave a comment: