Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
When the valve fails (not if it fails) I typically replace it with an elbow to permanently solve the issue. I have a brass vacuum breaker (available at...
-
Trailer manufacturers are famous for using the drill point screws. The drill point or "tek" screws are very convenient but produce a weaker...
Leave a comment:
-
Unless the trailer has been pulled forward in a straight line for 100 ft or so its impossible to determine, they do shift around quite a bit when turning...
Leave a comment:
-
That looks more like someone forgot to put them in during assembly or they were removed for an adjustment and just not put back. If there are holes already...
- 1 like
Leave a comment:
-
My experience has been that the dealers are often inclined to say its "good enough" because for them it is a money losing proposition to deal...
Leave a comment:
-
If you could post a picture it would help to determine a course of action. I would always avoid going longer on any screw in a trailer. You never know...
Leave a comment:
-
If you can post some pictures of the area and the screws in question it may help in determining the issue....
Leave a comment:
-
The upper carriage bolt goes through one of the lug holes at the 12 Oclock position on the wheel. The lower carriage bolt goes into the center hole on...
Leave a comment:
-
I drilled an 1 1/2" hole in the rear wall of my 2600RB for an auxiliary 110v power connection by using my standard stud finder....
Leave a comment:
-
I was in the Atlanta area in March when the price of gasoline jumped to over $4 gallon and rumors of shortages started, its not a good feeling when youre...
Leave a comment:
-
I think you have some "hybrid" U-bolts
Mine was easy, they have the flange nuts and looked to be 1/2"...
Leave a comment:
-
I had a 2008 Outback that had a tire developing an uneven wear pattern where the inner tread was wearing faster than the outer. I suspected a misaligned...
- 1 like
Leave a comment:
-
I did the same thing Rob. My inspection did not reveal any of the potential problems.
Given my past history with my dealer I have every confidence...
Leave a comment:
-
This video is very well done and shows the possible adjustments.
https://www.google.com/search?q=lipp...s0PEPl4Wa6A430
I would caution...
Leave a comment:
-
Pg 67 of the manual has U-bolt torque values. https://www.dexteraxle.com/user_area...ice_manual.pdf
I had previously...
- 1 like
Leave a comment:
-
You might also visually check for any debris or obstructions on the roof. Did it work okay previously ?...
Leave a comment:
-
My experience with the trucks at work was that these retainers fail regularly, some were made of heavy steel with a cap screw holding the U-shaped metal...
Leave a comment:
No activity results to display
Show More
Leave a comment: