Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
After successfully replacing the decals on the slide out that were damage, I noted that the decals on the top of my front cap were in pretty good shape...
-
Yep, I have the merit badge on this one. I put a pin in to lock the spring and when I brought the awing down, the locking pin fell out. I ran for my...
Leave a comment:
-
We used six of these when we held the Quartsite Arizona rally last winter. They held up very well in strong winds.
Jim...
Leave a comment:
-
Even if the vent pipe is too far into the tank, the liquid level would have to be higher than the top of the tank for it to reach the screw hole. The...
Leave a comment:
-
-
-
As an afterthought. I only used about 7 oz. of the 16 oz. bottle of GraphXOff for this job. So it goes a long way!
Jim
Leave a comment:
-
How to Replace Decals
After 5-1/2 years of sun exposure and a rally vendor who used a wax that was not "decal friendly", I had to replace a few decals.
...
- 5 likes
-
Jim,
I see both gray tanks and the black tank are part number HT466. On the GDRV website, the dimensions are listed. Here's a link:...Last edited by TucsonJim; 06-20-2022, 07:20 PM.
Leave a comment:
-
The power source depends on the model and year. Earlier models were powered up 24/7. Later models were powered via the running lights. Mine was continuously...
Leave a comment:
-
Before purchasing one, determine if you want a "backup" or "observation" camera. A back up camera is typically only powered while...
Leave a comment:
-
The wind may just be a coincidence. Check out this video where a 1210 owner shows how to basically "reboot" the refrigerator.
...
Leave a comment:
-
Hi Mike,
I did some looking at the floorplans and drawings for your 21BHE. I can certainly see the problem with the vent over the top bunk...
Leave a comment:
-
Hi Gary, Welcome to the forum.
I pulled the print on your unit. It is located behind the false wall in the basement storage area.
...
Leave a comment:
-
No, the nut that holds the mid section onto the base was tight, and due to the slots, it couldn't have rotated. I can't put too much blame on the factory...
Leave a comment:
-
Wow - This is really getting interesting. If it works fine with the other truck, I'm thinking it has to be a problem with the truck. Just a thought....
- 1 like
Leave a comment:
-
Every piece of vinyl covered wood in my coach bubbled. It's typically caused by low humidity. When the underlying wood dries out, the wood shrinks,...
- 1 like
Leave a comment:
-
Attic Vent Cover - Replacement and Repair
I was doing my quarterly roof maintenance and found that the attic roof vent was damaged and cracked due to UV exposure. While replacing the outer cover,...
- 2 likes
No activity results to display
Show More
Leave a comment: