Scott'n'Wendy
Contributor
Last Activity: 06-24-2022, 06:23 AM
Joined: 09-27-2020
Location: Thunder Bay, Ontario, Canada
-
$2.39/litre here in Northwestern Ontario as of yesterday...x4 for a US gallon -
Scott'n'Wendy replied to Water pump - Slow to charge, runs a long time, dismal pressure with air sputteringin PlumbingWhile not with my GD trailer, this was the issue on my previous trailer. The cup had worked it's way loose. Tightened up and all good. Hope yours is...Leave a comment:
-
So the temp swings I'm seeing is likely common then? I only recently placed bluetooth temp sensors in the fridge and freezer for monitoring and was surprised...Leave a comment:
-
Fridge temp regulation
We have a Norcold 1210 four door fridge. Works reasonably well for the most part. The problem I see is regulation. My freezer goes from -7*C to -15*C.... -
4 ga for 20 amps seems a little excessive? Won't hurt, except for the wallet I guess but 10 ga would be just fine.Leave a comment:
-
Like Jim, I don't boondock without a rifle or shotgun, but, Im not sure what the rules are regarding a US citizen bringing a hunting type firearm into...Leave a comment:
-
The chap at the border was very nice, let me cross with WAY over my limit of booze, which is, if you don't know, 1.14 litres of liquor, OR a case of beer...Leave a comment:
-
Or....he's actually crazy...lol
Yoda We drove I15 from Yellowstone up into Alberta at Coutts. Drive was nice with low traffic...Leave a comment:
-
High winds would probably help it cool better by blowing the hot air out from the rear of the fridge. Check the flap and door sealing as well, sometimes...Leave a comment:
-
Are all the lines behind the basement wall 1/2"?...Leave a comment:
-
I was thinking piston return springs.....or muffler bearings....or a mis-aligned saddle-over-bindelrotor.......Leave a comment:
-
And I thought the answer to what's whacky here is "where is the engine?"...lotsa plumbing and pipes.
The elastic bands remind me of back...Leave a comment:
-
Pretty sure I saw Yoda at a stand up gig in a bar not too long ago....
Leave a comment:
-
I'm at a loss for words on this one...lol...Leave a comment:
-
Nice looking anchors. What do you tie down with an anchor that high though? I like using the cleats low down close to the bed.Leave a comment:
-
I think there is a thread here somewhere on it. It's one of the first things I saw on this site when I joined. After seeing it, I remember thinking this...Leave a comment:
-
Just my opinion....I would raise the pin box one set of bolt holes....if you can.
Or maybe it's the front jacks holding the trailer up? It's just...Leave a comment:
-
I did not know that. Thanks. Good to know.
I'd fill my own until they were nine years old...then swap them out for one or two year old t...Leave a comment:
-
Engineers..........
Leave a comment:
-
I don't know. I don't use the EZ lube feature but according to this dexter video you would think the old grease would be displaced before you saw the...Leave a comment:
No activity results to display
Leave a comment: