Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Cmos sounds to me like stuff that washes up on the beach.
-
Ah, the mystery of electricity. Devices like heaters are resistive loads. So lower voltage results in lower current and less heat. Even though they...
- 2 likes
Leave a comment:
-
Just for reference, the water pressure may rise 50 to 100 psi per degree F as water heats in a water solid system.
Leave a comment:
-
I will disagree. Current will not increase as voltage drops. E = I x R Ohm's law. E and I are directly proportional.
If you assume power demand...
Leave a comment:
-
The water pressure can rise to the water heater relief valve setting which is 150 psi. The rv water system is nominally built for about 100 psi. PEX by...Last edited by TedS; Yesterday, 03:15 PM.
Leave a comment:
-
Well, certainly. Higher voltage will push more current through a given load. Hence, higher load demand. Will you be satisfied with appliaces under-performing?...
Leave a comment:
-
The boiling point or turning liquid to vapor is dependent on both temperature and pressure. At atmospheric pressure it boils at -44F. Put propane in a...
Leave a comment:
-
Running two generators each 59 bB results in a sound level of 62 dB. Still less than one at 64 dB. I would pay more for less noise, especially for use...
- 1 like
Leave a comment:
-
Red Regulator's Purpose
I did a search here to find the answer to why have the red regulator between the cutb-side tank and the crossover hose. Did not find an answer.
...Last edited by howson; 04-11-2021, 05:45 PM.
- 1 like
-
Make sure the shore power cord is well connected to the trailer.
Leave a comment:
-
-
As a reminder, do not use splash-free bleach. It is not for sanitizing.
Leave a comment:
-
-
-
The 3 psi below cutin is for the advertised use of reducing the pressure ripples of the pump flow and provide some water storage after the pump shuts...
- 1 like
Leave a comment:
-
I set the accumulator pressure above the pump cutout pressure since its only function is to absorb water heater expansion. That is still a tolerable...
Leave a comment:
-
Howson,
in your schetches, the nautilus valve shown to the right of the water heater should be to the left. It directs water to either the water...
Leave a comment:
-
Look at the pdf in my response #94. The spacer that the thrust bearings push against is held to the outer tube by upset spots in the outer tube.
...
Leave a comment:
No activity results to display
Show More
Leave a comment: