Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I also found my 60A would trip on my Ford. I couldn't get an 80 in time so I installed a 100 and have had no issues. The 4AWG should be good for 100A...
-
I can definitely vouch for my Dometic having a spring. That was a hard learned lesson. Still not a bad repair if you have a buddy or two and some ladders,...
Leave a comment:
-
jimgoings That battery is rated by a reserve capacity of 140 rather than an ah rating. That usually happens when the battery isn't a purpose built deep...
- 1 like
Leave a comment:
-
I had a old fridge in my garage that worked that way. It was a detached garage, and I found out the hard way when the ambient temp got below fridge temp,...
Leave a comment:
-
Okay then the next question would be how much current you see going into the shunt. It should be positive if it's charging. That'll be the sum of your...
Leave a comment:
-
It should not need to be calibrated, I believe on that monitor you just need to tell it the total number of amp-hours your battery bank has. This would...
Leave a comment:
-
I would think it should. There's instructions for doing it via USB key which might be easier on an actual Cerbo. The developer used to have a CCGX before...
Leave a comment:
-
ncitro replied to Water pump - Slow to charge, runs a long time, dismal pressure with air sputteringin Plumbingregularguy2k Welcome to the forum! I would be surprised if it was anything to do with the pickup, there isn't a pickup tube in the tank, there is a bulkhead...
Leave a comment:
-
Victron Cerbo/CCGX/Venus UI Mods
I spent the last few nights at a Provincial Park in Ontario. For those that have not been, its common in these parks for the power pedestal to be shared...
-
-
chikenstiker I like a lot about the Gen Y. I have not driven it, but I have ridden in my buddies truck with it and I think the ride is similar to my GooseBox,...
Leave a comment:
-
-
Sam Gaddis Also if you have the Furrion shunt, check out this thread and its links. It is likely your dealer did not set the shunt up properly, so your...
Leave a comment:
-
I would not say that sounds normal, but it depends on how big or how many batteries you have (they are not included by Grand Design, its up to the dealer...
Leave a comment:
-
chikenstiker Yeah it was a beast. I used the forklift so I could align it to the holes in the wing set. You could certainly do it with two guys and setting...
Leave a comment:
No activity results to display
Show More
Leave a comment: