Disclaimer: In general, this forum is intended to be a place for Grand Design owners to gather and exchange ideas regarding their use of and experiences with Grand Design products. Any information contained in the forum should be independently verified by checking with Grand Design, one of its authorized dealers, or reviewing your owner’s manual.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will need to to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below. Thanks for visiting and your interest in Grand Design!
Need a long Robertson (square) bit when working on the RV? Consider picking up a Kreg bit at your local hardware store. Not too expensive and works great.
Forum moderators are not GD employees--we are volunteers and owners presumably just like yourself. Unless specifically mentioned otherwise, we have nothing to gain should you choose to purchase a product or engage a service we discuss on this forum.
Need a long Robertson (square) bit when working on the RV? Consider picking up a Kreg bit at your local hardware store. Not too expensive and works great.
Ok I'll bite - what are you working on now that needs that long bit?
Great tip too
Keith
2018 Reflection 150 Series 220RK 5th whee, Star White 2022 F350 King Ranch CC Long bed (HAL) (CCC 4062lbs), B&W 25K OEM Companion,. SteadyFast system, Trailer reverse lights, rear receiver spare tire holder, storage tube, sumo springs, Victron MultiPlus 12/120/3000, Solar, Custom 6K axles upgrade, and other modifications.
Yoda Everything. Those long drive bits are designed to fit down in the pocket screw holes, but tend to have a better tip than some of the other ones. Longer bits like that are nice because you can put them directly in the driver and minimize the number of joints that allow for out of alignment.
Removing the microwave screws is much easier with this long bit and a power drill. (I was doing the Refrigerator Power Switch mod.) Torque on the drill set to 1 on reinstall as I've learned through hard experience that screws get snugged on an RV, not tightened.
Forum moderators are not GD employees--we are volunteers and owners presumably just like yourself. Unless specifically mentioned otherwise, we have nothing to gain should you choose to purchase a product or engage a service we discuss on this forum.
Yoda Everything. Those long drive bits are designed to fit down in the pocket screw holes, but tend to have a better tip than some of the other ones. Longer bits like that are nice because you can put them directly in the driver and minimize the number of joints that allow for out of alignment.
Thanks Joseph Ill have to get one, or better yet get the full Kreg kit. Maybe Fathers day???
I was just trying to find out if Howard howson was working on something that is going to cost me $$$$ again Others seem to be doing that today (Lippert step attachment)
Well out to work on getting my bar stock to fit the switch and Lynx power in - more holes to drill and connections to be made.
2018 Reflection 150 Series 220RK 5th whee, Star White 2022 F350 King Ranch CC Long bed (HAL) (CCC 4062lbs), B&W 25K OEM Companion,. SteadyFast system, Trailer reverse lights, rear receiver spare tire holder, storage tube, sumo springs, Victron MultiPlus 12/120/3000, Solar, Custom 6K axles upgrade, and other modifications.
Comment