Disclaimer: In general, this forum is intended to be a place for Grand Design owners to gather and exchange ideas regarding their use of and experiences with Grand Design products. Any information contained in the forum should be independently verified by checking with Grand Design, one of its authorized dealers, or reviewing your owner’s manual.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will need to to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below. Thanks for visiting and your interest in Grand Design!
It reads like the OP has made their decision, but I wanted to trough out there that this may be a good time to consider replacing the laminate countertop with a solid core one.
I think that just installing a drop in sink will serve me well, at least for the rest of the time that I have this trailer. The rest of the countertop is in great shape, as well as the one in the bathroom. The bathroom has a drop in fingerbowl sink which I will be replacing with a larger one. As long as I seal the underside of the lip well when I install it, I think that will be the end of my problem. As much as I would like to, I really don't want to go through the expense right now of replacing the countertop.
Thanks everyone for the suggestions.
By the way, JBill9694 "Every day is Saturday" is my favorite saying also. Retirement is nice!
It reads like the OP has made their decision, but I wanted to trough out there that this may be a good time to consider replacing the laminate countertop with a solid core one.
The description on the parts page states that it is a bottom mount sink. It is attached with clips so there should be no holes in the rim. I does look like it will fit if dropped in from the top. The question is how good does the tip of the rim look after I remove whatever adhesive is on it? I will not know unless I remove it. I guess a call to GD is the next step.
Mike, I've been thinking about your issue. Unfortunately there is not a good way to re-attach the laminate foil to the substrate. I agree with Howard that the top of the sink is probably not setup for the rim mount (no water retention lip and possibly holes in the lip from attaching the sink). You might try contacting GD to see what they say (they may replace it depending on age), other than that, I might consider having cultured marble (or some other solid material) made for the counter top and doing away with the foil surfacing.
AZMike -- I can't recall this issue being discussed on the forum. From the pictures it does not appear it's possible to mount from the top as the rim is likely not going to look very good. At first I was going to suggest some sort of trim, but that would make wiping the counter into the sink difficult.
I'd consider removing the sink to have full access with the goal to re-seal the top layer to the substrate. A good epoxy glue perhaps and then some clamps strategically placed to hold it in place? (I'm not much of a wood-worker type so all this is conjecture to generate ideas.)
I have the very nice 23" x 13" rectangular sink in my 2600RB. The covering is pulling away from the wooden base from water intrusion due to not being sealed very well during installation. Can this sink be removed and mounted from the top of the counter? Has anyone done it? I was able to shrink it by heating it with a hair dryer and running a bead of silicone around the sink once I dried it out as a temporary fix.
Leave a comment: