Integrating control systems with the OneControl platform and adding more components

[bob]

I use an ESP32 and display the info locally or over wifi...

[ralbright]

So bob, what new changes have you made in the last 6 months? Have you been able to integrate HA into your new coach's OneControl setup?

[bob]

So bob, what new changes have you made in the last 6 months? Have you been able to integrate HA into your new coach's OneControl setup?

Well, a lot actually, but I haven't had much time to go after the X1.5 board (yet).

I decided that since my coach only had 4 lights controlled by OneControl, it would be a bigger lift trying to get all the everything nto OneControl, then HA, so this is what I've done so far:

1. i added i think 12 or 14 Shelly 1's to control all the interior and exterior lights
2. Added a Tempest weather station
3. Added 28 zigbee motion, temp, water, and door sensors
4. Replaced factory smoke detectors with zwave units, plus added smoke detectors in the pass through storage and the forward storage compartments
5. Rolled sensors into alarmo for security and leak alarm notifications
6. Added Hughes Autoformer data into HA with esp32
7. Added mopeka tank info via esp32
8. Added Linktap G2S water control valve and flow sensor - now rv water is shut off whenever there is a leak, or when I arm the alarm
9. Built custom flood sensors to watch for unusual tides
10. Rebuilt control base onto Dell 7050 usff PC running proxmox
11. Added cyberpower ups and integrated that into HA so if the power drops, i can send alerts, take actions, etc.
12. Integrated b-hyve garden watering system
13. Integrated remote access/visibility through cloudflare tunnels right to the Proxmox host

There is s a ton I am forgetting , but that's the gist!