Tweet
Just completed this on my 2024 2670MK. I took the head off, then discovered the holes were already tapped ! I really didn't need to take it off - just rotate it 90 degrees. Anyone with a 2024 or later might just try turning the head and see if the bolts thread in. If they do, it is a three minute job. If not, a 15 minute job.
- Disclaimer: In general, this forum is intended to be a place for Grand Design owners to gather and exchange ideas regarding their use of and experiences with Grand Design products. Any information contained in the forum should be independently verified by checking with Grand Design, one of its authorized dealers, or reviewing your owner’s manual. If this is your first visit, be sure to check out the FAQ by clicking the link above. You will need to to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Thanks for visiting and your interest in Grand Design!
Comment