I have a 2018 Reflection 337RLS. I have the underbelly off to install tank heaters, better insulation around the tanks, seal up rodent pathways, and clean up rust. I noticed the floor joists aren't fastened to the cross members. I was thinking of driving some self-tapping screws into them at every point where they intersect (at least the ones I can get at). I'm also thinking about fastening the last cross member to the rear wall. There seems to be a bit of movement between the rear wall and floor. The screws in the small angle trim behind the couch have been popping out since this trailer was new. I know there is some flex in the steel chassis and aluminum framing in the walls and floor, so I'm not sure these additional fasteners won't cause problems.
Has anyone done this before?
I'm also seeing what I think is too much flex up front, but I'll post that where it's already been discussed.
Thanks,
Steve
Has anyone done this before?
I'm also seeing what I think is too much flex up front, but I'll post that where it's already been discussed.
Thanks,
Steve
Comment