OK one more question. When I out the coroplast an insulation back up I plan to span across with the angle iron (coroplast seam). I was thinking of tapping some 1/4" or 5/16" al thread (SS) between the tank support channels and tie it into the angle iron cross member for a center support, Doing this will remove the tank belly and possibly improve drainage for the tanks
Existing twin support tank channels. I wan going to tap the gap for the all thread. Was wondering if that would cause strength issues.
This is the channel between the tanks in the above photo. Also in the photo I need to re route the disconnect switch cables (red and black crossing the tank), or remove them as I have other disconnect switches in place.
Another photo of the double channel between the tanks. I could drill and tap at the center of the weld if that would be better.
Thanks for you thoughts
Keith
Existing twin support tank channels. I wan going to tap the gap for the all thread. Was wondering if that would cause strength issues.
This is the channel between the tanks in the above photo. Also in the photo I need to re route the disconnect switch cables (red and black crossing the tank), or remove them as I have other disconnect switches in place.
Another photo of the double channel between the tanks. I could drill and tap at the center of the weld if that would be better.
Thanks for you thoughts
Keith