2020 XLS 22 MLE Slide Switch Wiring

[TedS]

This is a diagram of a dpdt switch wired for motor reversing operation.

[rcoon1]

Jlawles2,

Yes that makes much more sense to move the center terminals rather than the PWR & GND! I will do that.

Thank you!

Roger C
2022 XLS 22 MLE

[rcoon1]

TedS,

Here (attached) is a picture of my switch.

My slide out is working fine now thanks to the input I got from the forum members!

Roger C
2022 XLS 22 MLE

[TedS]

rcoon1 this would be like your switch. The power and ground may be wired internally.

[Jlawles2]

TedS Ted, by looking at the picture posted in number #18 and previously, the cross over bus bars are on the outside of the switch.

Personally not a big fan of how close the bars look to each other.

[TedS]

Jlawles2 I noticed that. Instead of insulated jumper wires. It almost looks like two switches bonded to make one.

[howson]

rcoon1 -- Updated some of my posts as I wrote some inaccurate information. Sorry for any confusion--if I'd checked your VIN it would have been obvious.

Howard