What are y’all using to keep the hydraulic shaft from turning while putting the bolt that holds the foot pad on back in the bottom of the hydraulic shaft?
Which strength number loctite are y’all using to secure the threads. The high strength 271 states a torch is needed to heat the bolts so you can remove them in the future but Lippert say to use high strength.
suggestions please?
Thanks in advance!
Which strength number loctite are y’all using to secure the threads. The high strength 271 states a torch is needed to heat the bolts so you can remove them in the future but Lippert say to use high strength.
suggestions please?
Thanks in advance!
Comment