We picked up our 2020 Solitude 310GK-R yesterday with the optional 300w factory solar system. I see two problems so far:
1- There is one 4/0 wire from the 2000w inverter to the positive side of one battery and another 4/0 wire from the inverter to the negative side of the second battery. However, the dealer installed either 8awg or 6awg wires (didn't look that close) to connect the batteries in parallel. I'm no electrical engineer but it seems to me the wires connecting the batteries should also be 4/0. Is that correct? If so, it seems Grand Design should instruct the dealers in the correct way to wire up the batteries.
2- I'm getting an error on the Jaboni solar charge controller. It displays "Error Code 01: High Bat Voltage". I looked at the Jaboni manual and it says this error can be caused by "The battery bank is receiving charge from another controller; Battery cable loose or was disconnected while charging." I tightened the rats nest of wires connected to the batteries but I still get the error even after turning the charge controller on and off several times. Has anybody else seen this error?
1- There is one 4/0 wire from the 2000w inverter to the positive side of one battery and another 4/0 wire from the inverter to the negative side of the second battery. However, the dealer installed either 8awg or 6awg wires (didn't look that close) to connect the batteries in parallel. I'm no electrical engineer but it seems to me the wires connecting the batteries should also be 4/0. Is that correct? If so, it seems Grand Design should instruct the dealers in the correct way to wire up the batteries.
2- I'm getting an error on the Jaboni solar charge controller. It displays "Error Code 01: High Bat Voltage". I looked at the Jaboni manual and it says this error can be caused by "The battery bank is receiving charge from another controller; Battery cable loose or was disconnected while charging." I tightened the rats nest of wires connected to the batteries but I still get the error even after turning the charge controller on and off several times. Has anybody else seen this error?
Comment