The following was extracted from a long troubleshooting thread at https://gdrvowners.com/forum/operati...-only-clicking Info below is too good to "bury" there. Content is edited for brevity but original contributors are credited where appropriate.
Note the switch discussed is on a non CompassConnect (or OneControl) equipped trailer.
This first post showed the switch that was expected. As you'll read that's not what was found.
--------------------------------------------------------------------------------------------------------------------
The diagram below is from the Electric Through Frame Slide-Out System Service Manual (same place TedS got the other diagram).
-----------------------
Dave27's response:
The switch isn't like either of these. And the wires aren't color coded! The ground is on the right side by itself in the middle when you look at the back. There are three inline vertically on the left. The middle must be coming from the battery (it measures 12.6 V, same as the battery), and I assume the upper one is to bring the slide in, and the lower one to extend the slide.
-------------------------
My reply to Dave:
...that explains it very clearly, thank you! GD is using their own switch, not Lippert's, so the manual's diagram is instructive but not definitive.
Note the switch discussed is on a non CompassConnect (or OneControl) equipped trailer.
This first post showed the switch that was expected. As you'll read that's not what was found.
--------------------------------------------------------------------------------------------------------------------
The diagram below is from the Electric Through Frame Slide-Out System Service Manual (same place TedS got the other diagram).
-----------------------
Dave27's response:
The switch isn't like either of these. And the wires aren't color coded! The ground is on the right side by itself in the middle when you look at the back. There are three inline vertically on the left. The middle must be coming from the battery (it measures 12.6 V, same as the battery), and I assume the upper one is to bring the slide in, and the lower one to extend the slide.
-------------------------
My reply to Dave:
...that explains it very clearly, thank you! GD is using their own switch, not Lippert's, so the manual's diagram is instructive but not definitive.
Comment