I was cleaning slide out seals today & noticed that both hydraulic slides on my 310GK were out of adjustment front to rear. Measured & there is a 1/2 inch difference. The seal on the tight ends are starting to get torn up.
There are four bolts under each slide (two on both ends) in slotted holes, Is this something I can adjust myself? Slideouts out or in? Do I need to prop slide with jack stands? Loosen the bolts & give it a shove?
Any tips & tricks before I tear into this is appreciated.
There are four bolts under each slide (two on both ends) in slotted holes, Is this something I can adjust myself? Slideouts out or in? Do I need to prop slide with jack stands? Loosen the bolts & give it a shove?
Any tips & tricks before I tear into this is appreciated.
Comment