The top portion on the front jack on the driver's side on our trailer is extended further than the other. I'm 99% sure the picture below was taken when the trailer was connected to the truck, and I had just retracted the jacks. Although during a "retract all" sequence to clear a landing gear fault (low batteries) I did see that passenger side jack come off the ground the front of the trailer was supported solely by the driver's side jack. So far, I have compensated by just using more leveling blocks under the other jack - but something tells me I need to figure out how to get them to deploy and retract evenly. I held down the retract button until the offending jack was fully retracted, but it seems it's even more out of alignment with the other jack the next time I used them to level the trailer.
Will re-setting the 0-point help with this? Or does it need some other fix?
Will re-setting the 0-point help with this? Or does it need some other fix?
Comment