This helps, Keith. I'm going to figure out a way to divert the drip out the pass through hole in the I-beam so I can monitor it and wipe it occasionally. It has been dripping on the coroplast for a long time and made a mess. The cylinder otherwise works fine, so would rather not replace and endure that hassle/expense.
I could repurpose the heat shields from some exhaust uppipes I replaced on my 7.3L diesel to make a sloped tray that can be zip tied to the cylinder and just poke out the I-beam hole, if cut to length.
That "wood" is just some dirty plastic wrap - not sure why it's there - I removed it.
I could repurpose the heat shields from some exhaust uppipes I replaced on my 7.3L diesel to make a sloped tray that can be zip tied to the cylinder and just poke out the I-beam hole, if cut to length.
That "wood" is just some dirty plastic wrap - not sure why it's there - I removed it.
Comment