I thought I would start this partially as TucsonJim was looking too. I spoke with Morryde and they said the UO21-003 would fit my center hanger, but that my end hanger were too wide and to use thier weld on RE21-004 However after reading the instructions (page two) I could just drill a hole in my wider hanger. https://www.morryde.com/wp-content/u...structions.pdf
Am I reading the instructions correctly?
I also heard back from Jennifer at morryde.com - Good afternoon. We do still make the UO21-003. If your front and rear frame hangers are the same as the photo, yes, you would have to put one hole in the frame hanger for the bolt to go through. It will wrap around the other side on the perpendicular side.
I am thinking of doing all three locations based on my frame cracks I found. Post to come, but locations and cracks are similar to the face book posting for the Reflection 220RK found here https://www.facebook.com/groups/316794188993517
I will be starting a new thread on the cracks, but the short of it is Lippert did open a case for me even though I am past warrenty
So back on topic - Is anyone using this brace and how is it doing?
Thanks
Keith
Other information sources
https://www.etrailer.com/Accessories...de/MR49ZR.html
Dimensions of the end plate
https://www.etrailer.com/question-612447.html
https://www.morryde.com/products/x-factor-crossmember/
On edit found another article
https://www.morryde.com/wp-content/u...ticle-2017.pdf
Am I reading the instructions correctly?
I also heard back from Jennifer at morryde.com - Good afternoon. We do still make the UO21-003. If your front and rear frame hangers are the same as the photo, yes, you would have to put one hole in the frame hanger for the bolt to go through. It will wrap around the other side on the perpendicular side.
I am thinking of doing all three locations based on my frame cracks I found. Post to come, but locations and cracks are similar to the face book posting for the Reflection 220RK found here https://www.facebook.com/groups/316794188993517
I will be starting a new thread on the cracks, but the short of it is Lippert did open a case for me even though I am past warrenty
So back on topic - Is anyone using this brace and how is it doing?
Thanks
Keith
Other information sources
https://www.etrailer.com/Accessories...de/MR49ZR.html
Dimensions of the end plate
https://www.etrailer.com/question-612447.html
https://www.morryde.com/products/x-factor-crossmember/
On edit found another article
https://www.morryde.com/wp-content/u...ticle-2017.pdf
Comment