Good morning
I have been searching, watching YouTube videos, and reading programing tips/tricks before installation on my Victron equipment. There is lots on programming the MultiPlus system. You need to provide power to the unit (either 110 or 12V) and connect using the MK3 adapter. Of course it is understood I need to download the programing software.
However there is very little I can find on programing the SmartSolar MPPT charger controllers before installation. I was hoping to do it inside at my desk by plugging in a 12V battery to the output circuit. I have better light conditions to use my phone. Can they only be programed using the Bluetooth or can they be hooked up to the computer in some way similar to the MultiPlus. The other answer I nave not found is whether the SmartSolars retain the programing when power is removed.
I also have the BMV 712 battery monitor that need setting up, but it appears that programing can easily be done once hooked up to the batteries and using the buttons on the face plate - or did I miss something?
Any how to links would be appreciated - Thanks
Keith
Now back to finishing the taxes
I have been searching, watching YouTube videos, and reading programing tips/tricks before installation on my Victron equipment. There is lots on programming the MultiPlus system. You need to provide power to the unit (either 110 or 12V) and connect using the MK3 adapter. Of course it is understood I need to download the programing software.
However there is very little I can find on programing the SmartSolar MPPT charger controllers before installation. I was hoping to do it inside at my desk by plugging in a 12V battery to the output circuit. I have better light conditions to use my phone. Can they only be programed using the Bluetooth or can they be hooked up to the computer in some way similar to the MultiPlus. The other answer I nave not found is whether the SmartSolars retain the programing when power is removed.
I also have the BMV 712 battery monitor that need setting up, but it appears that programing can easily be done once hooked up to the batteries and using the buttons on the face plate - or did I miss something?
Any how to links would be appreciated - Thanks
Keith
Now back to finishing the taxes
Comment